Hard wearing end caps for water fed window cleaning poles. Drilled with hole for pole hose.(Except 54mm Caps which require drilling)
Material: Rubber or plastic depending on stock.
May vary from slightly from picture.
Streamline Code: P-BUTT-?? (Where ?? represents the pole size in mm) Except 54mm cap which is Code: X-BUTT-54.
For more information, please see below:
Warning: Last items in stock!
What does a Pole Base Cap do? It has an important function, it protects the base of a water fed window cleaning pole. It also helps feed the pole hose up the centre of the pole.
My pole Base Cap is damaged; do I need to replace it? It depends upon how damaged it is. If the lower end of base cap has worn away leaving the pole sections exposed and pole hose could be damaged by the rough end of the pole – then yes it needs replacing. If the Pole Base Cap is not replaced the outer section of the pole will be damaged when it is lent against a wall. This damage could cause it to splinter, presenting a handling problem. Or it could cause a split in the pole, so by reducing the pole life.
How do I remove a damaged Pole Base Cap? Carefully. First remove the pole hose. Most Pole Base Caps are glued in place. It may be possible to use a hacksaw to cut through the cap before peeling it off. If this method is used then great care must be taken not to damage the pole.
Caution: When the cap has been removed, examine the end of the pole. If it is badly damaged then it may need to have small part cut off. Please collapse the pole to check that any shortening of the out pole will not result in any of the inner sections protruding beyond the end of the outer section.
Which Pole Base Cap do I need? Window Cleaning Stuff stock a good range of Pole Base Caps. Start by picking a range that looks similar to the cap that you are replacing. Now measure the diameter of the outer section of the pole. Select the correct size of Pole Base Cap. You will also need a good glue such as PenLoc Adhesive Code WXW95.
How do I fit one? With the damaged cap and the pole hose removed, check that the replacement Pole Base Cap is the right size and fits the outer pole section. It should be a snug fit. Use a suitable abrasive paper to roughen the surface of the pole where the cap will be. Do not rub too much, only a light key for the adhesive is required. Do the same with the inside surface of the cap.
Lie the pole flat, in a warm and dry location. Place something under the part of the pole that you are working on, to protect the floor from any drips of adhesive. Have a cloth handy for any drips or spills.
Important: Slightly extend the pole so that none on the inner sections are close to the pole end.
Apply a thin even coating of adhesive around the end of the pole. Slide the cap on while turning it to spread the adhesive evenly. Remove any excess adhesive.
Tip: Let it dry overnight, before refitting the pole hose.
Please complete the form below providing us with details of the offer you've seen. We will confirm the price match for you. Your special price will appear on your account for one month.